Amercoat 237M Epoxy Non-Skid This item has been Discontinued Product Data Hard, tough epoxy coating containing hard non-skid grit Non-skid grit predispersed in epoxy component Long lasting, positive non-skid properties Maximum adhesion to steel, aluminum and concrete Easy spray or roll-on application VOC (EPA 24) lb/gal g/L mixed 2.2 264 Volume solids (ASTM D2697, modified) 67% ± 3% Dry film thickness per coat 2-6 Mils (50-150 Microns) Practical Coverage 80 sq ft per gallon at 1 mil thickness Qualifications U. S. Naval Ships' Technical Manual, Chapter 631 Military Sealift Command Instructions 4750.2 Approval - MIL-PRF-24667A Typical Uses Offshore platform decks Helicopter pads Aircraft hanger floors Vehicular decks Truck ramps Exposed walkways of all types Any areas where heavy-duty non-skid properties are required Recommended Thinners Amercoat T-10     Recommended Cleaner Amercoat 12 or Thinner Click here for Product Data Sheets (page will open in new window)

Amercoat 138G Epoxy Non-Skid Product Data High solids two-component epoxy Roll-on application - Creates a unique ridge formation Very hard, non-wearing grit - Grit is pre-mixed into the base component Heavy-duty-Very long-lasting non-skid properties VOC (EPA) lb/gal g/L mixed 1.11 133   Volume solids (Calculated) 82% ± 3%   Coverage/spreading rate ft²/gal m²/L Practical 25 - 35 0.62-0.86 Typical Uses Aircraft carrier decks Vehicular ramps and decks Offshore decks Other very heavy-duty service areas where non-slip properties are required Qualifications MIL-PRF-24667 C, Type I & II Composition G - General use abrasive deck system (all types) Surface Preparation For NAVSEA applications, Chapter 634 guidelines must be followed. Recommended Thinners Amercoat T-10 Recommended Cleaner Amercoat 12 or Thinner Click here for Product Data Sheets (page will open in new window)